Application Instructions for the Exoform Ankle Brace by Royce

Mild to moderate sprains and strains; injury prevention,

chronically weak ankles.

1. Patients should be instructed to inspect their foot, ankle, and

this product before and after each use.

2. This product is designed to be worn over an athletic sock.

If any problems occur with this product please contact your

certified medical professional. Measure ankle circumference

over an athletic sock around the base of the heel and across the

ankle bone to compare with the sizing chart to ensure proper

product fit.

A. Speed Laces(1) with eyelets(2)

B. Figure-8 Straps

C. Tongue

D. Heel opening

1. Disconnect Figure-8 Straps(if applicable) and loosen laces.

Insert foot into the brace toes first. Place heel securely into the

heel opening. Adjust the tongue if necessary making sure the

tongue is on top of the foot.

2. Lace up the brace using either the speed lace hooks(a) or the

standard eyelets(b).

3. For version with Figure-8 straps: Wrap the inside (medial)

strap over the top of the laces and underneath the foot.

4. Fasten the end of the strap on the loop material located on

the inner side of the brace. Wrap the outside (lateral) strap over

the top of the medial strap and underneath the foot. Fasten the

end of the strap on the loop material located on the outer side

of the brace.

5. Stand and apply full weight to the brace. Adjust straps to

ensure a snug fit and maximum support.

6. Readjust laces as needed to ensure a supportive fit.

1. This product may be cleaned using a mild detergent and cold

water. Remove shoe laces and hand wash separately. Fasten

straps as if in use. Do not use bleach or strong detergents.

2. Lay brace out flat on a towel and air dry. Do not squeeze or

wring out the brace. Do not place in dryer or near heater.

Inspect brace carefully after each washing.